5 system lockout, 6 resetting the defaults, 1 resetting the defaults via command – ZyXEL Communications IES-708-22A User Manual
Page 382: 5 system lockout 56.6 resetting the defaults, Figure 132 resetting the ies-708-22a via command
Chapter 56 Troubleshooting
IES-708-22A User’s Guide
382
56.5 System Lockout
Any of the following could also lock you and others out from using in-band management
(managing through the data ports).
1 Deleting the management VLAN (default is VLAN 1).
2 Incorrectly configuring the CPU VLAN.
3 Incorrectly configuring the access control settings.
4 Disabling all ports.
"
Be careful not to lock yourself and others out of the system.
If you lock yourself (and others) out of the system, you can try using the console port to
reconfigure the system. See
56.6 Resetting the Defaults
If you lock yourself (and others) from the IES-708-22A, you will need to reload the factory-
default configuration file. Uploading the factory-default configuration file replaces the current
configuration file with the factory-default configuration file. This means that you will lose all
previous configurations and the speed of the console port will be reset to the default of 9600
bps with 8 data bit, no parity, one stop bit and flow control set to none. The user name will be
reset to “admin” and the password will be reset to “1234” and the IP address to 192.168.1.1.
56.6.1 Resetting the Defaults Via Command
If you know the password, you can reload the factory-default configuration file via Command
Line Interface (CLI) command. Use the following procedure.
1 Connect to the console port using a computer with terminal emulation software. See
for details.
2 Enter your password.
3 Type
config restore
.
4 Type
y
at the question “Do you want to restore default ROM file(y/n)?”
5 The IES-708-22A restarts.
The IES-708-22A is now reinitialized with a default configuration file including the default
user name of “admin” and the default password of “1234”.
Figure 132 Resetting the IES-708-22A Via Command
ras> config restore
System will reboot automatically after restoring default configuration.
Do you want to proceed(y/n)? >
restoring configuration...
saving configuration to flash...