ZyXEL Communications IES-708-22A - Manual (Page 328)

Chapter 52 SNMP
IES-708-22A User’s Guide
328
where
Use this command to add the host IP address to the list of trusted hosts. If you enter a trusted
host, your IES-708-22A will only respond to SNMP messages from this address. If you leave
the trusted host set to 0.0.0.0 (default), the IES-708-22A will respond to all SNMP messages it
receives, regardless of source.
52.1.4 Trap Community Command
Syntax:
ras> sys snmp trapcommunity <community>
where
Enter this command with the community to set the password.
52.1.5 Trap Destination Set Command
Syntax:
ras> sys snmp trapdst set <index> <ip> [<port>]
where
Use this command specify the IP address (and port number) of a trap server to which the IES-
708-22A sends SNMP traps. If you leave the trap destination set to 0.0.0.0 (default), the IES-
708-22A will not send any SNMP traps.
52.1.6 Show SNMP Settings Command
Syntax:
ras> sys snmp show
This command displays the current SNMP get community, set community, trap community,
trusted hosts and trap destination settings.
<ip> = The IP address of a trusted host.
<community> = The password sent with each trap to the SNMP manager.
<index> = The number of the trap server (1~4).
<ip> = The IP address of the trap server.
[<port>] = The port number upon which the trap server listens for SNMP
traps. The IES-708-22A uses the default of 162 if you do not
specify a trap port.