ZyXEL Communications IES-708-22A - Manual (Page 168)

Chapter 22 MAC Filter
IES-708-22A User’s Guide
168
The following table describes the labels in this screen.
Table 48 Advanced Application > MAC Filter
LABEL DESCRIPTION
Port Use this drop-down list box to select a DSL port for which you wish to configure
MAC filtering.
MAC Type a device’s MAC address in hexadecimal notation (xx:xx:xx:xx:xx:xx, where
x is a number from 0 to 9 or a letter from a to f) in this field. The MAC address
must be a valid MAC address.
Add Click Add to save your changes to the IES-708-22A’s volatile memory. The IES-
708-22A loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Port These are the numbers of the DSL ports.
Mode Select Accept to only allow frames from MAC addresses that you specify and
block frames from other MAC addresses.
Select Deny to block frames from MAC addresses that you specify and allow
frames from other MAC addresses.
Active Select this check box to turn on MAC filtering for a port.
MAC This field lists the MAC addresses that are set for this port.
Delete Click Delete to remove a MAC address from the list.
Apply Click Apply to save your changes to the IES-708-22A’s volatile memory. The
IES-708-22A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.