ZyXEL Communications IES-708-22A - Manual (Page 362)

Chapter 54 Virtual Channel Management
IES-708-22A User’s Guide
362
54.6 PPPoA to PPPoE (PAE) Commands
This feature is available in STU-C mode only.
You can use these commands to create PVCs for PAE translation.
54.6.1 PAE PVC Delete Command
Syntax:
ras> shdsl paepvc delete <portlist> <vpi> <vci>
where
This command removes a PAE PVC.
54.6.2 PAE PVC Set Command
Syntax:
ras> shdsl paepvc set <portlist> <vpi> <vci> <DS vcprofile[,US vcprofile]>
<pvid> <priority> [acname <acname>] [srvcname <srvcname>] [hellotime
<hellotime>]
where
<portlist> = The port number of the PAE PVC. You can specify a single DSL
port <1>, all DSL ports <*> or a list of DSL ports <1,3,5>. You
can also include a range of ports <1,5,6~8>.
<vpi> = The VPI of the PAE PVC.
<vci> = The VCI of the PAE PVC.
<portlist> = The port number of the PAE PVC. You can specify a single DSL
port <1>, all DSL ports <*> or a list of DSL ports <1,3,5>. You
can also include a range of ports <1,5,6~8>.
<vpi> = The VPI of the PAE PVC.
<vci> = The VCI of the PAE PVC.
<DS vcprofile = Assign a VC profile to use for this channel’s downstream traffic
shaping.
[,US
vcprofile]> = Assign a VC profile to use for policing this channel’s upstream
traffic. The IES-708-22A does not perform upstream traffic
policing if you do not specify an upstream VC profile.
<pvid> = 1 – 4094; the VLAN Identifier to add to Ethernet frames that the
system routes using this PVC.
<priority> = Set the IEEE 802.1p priority (0~7) to add to the traffic that uses
this PVC.