ZyXEL Communications IES-708-22A - Manual (Page 335)

Chapter 53 DSL Commands
IES-708-22A User’s Guide
335
where
This command displays DSL port connection statistics including the wire pair, status (V for
enabled, - for disabled), actual rate, up time and the number of errored seconds.
The following example displays connection statistics for port 1.
53.2.2 DSL Port Linerate Command
Syntax:
ras> statistics shdsl linerate <portlist>
where
This command shows the transmission rates on a DSL port.
An example is shown next.
The following table explains these counters.
[portlist] = You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
ras> statistics shdsl show 1
actual rate
port wire pair status (kbps) up time error second(15M/24H)
---- --------- ------ ----------- -------------- ---------------------
1 2wire V 3776 00000:20:44:20 0/0
<portlist> = You can specify a single DSL port <1>, all DSL ports <*> or a
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
ras> statistics shdsl linerate 1
[port 1]
link = link_up
min rate = 5696 kbps
max rate = 5696 kbps
actual rate = 3776 kbps
noise margin = 26 dB
attenuation = 1 dB
linkup count = 1
Table 94 DSL Port Linerate Command Counters
LABEL DESCRIPTION
link This displays the connection status of the DSL link.
min rate This is the minimum rate (in Kbps) of the DSL line.
max rate This is the maximum rate (in Kbps) of the DSL line.