ZyXEL Communications IES-708-22A - Manual (Page 256)

Chapter 42 Commands
IES-708-22A User’s Guide
256
igmpsnoop mvlan group
set
<vid> <index>
<start_mcast_ip>
<end_mcast_ip>
(STUC mode only) Create a
multicast to VLAN translation
entry.
up to 16 entries
<index>: 1~16,
Note: IP address in each entry
should be disjointed
H/H
igmpsnoop mvlan group
delete
<vid> <index> (STUC mode only) Delete a
multicast to VLAN translation
entry.
H/H
igmpsnoop mvlan group
show
<vlanlist> (STUC mode only) Show a
multicast to VLAN translation
entry.
M/L
igmpfilter set <portlist> <name> (STUC mode only) Sets a DSL
port(s) to use an IGMP filter
profile.
H/H
igmpfilter show [portlist] (STUC mode only) Displays which
IGMP filter profile an DSL port(s)
is using.
M/L
igmpfilter profile set <name> <index>
<startip> <endip>
(STUC mode only) Configures an
IGMP filter profile.
H/H
igmpfilter profile delete <name> (STUC mode only) Removes an
IGMP filter profile.
H/H
igmpfilter profile show [name] (STUC mode only) Displays an
IGMP filter profile’s settings.
M/L
queuemap show Displays the system’s priority level
to physical queue mapping.
M/L
queuemap set <priority> <queue level> Maps a priority level to a physical
queue.
H/H
garptimer show (STUC mode only) Display the
system’s garp settings.
M/L
garptimer join <join msec> (STUC mode only) Set system’s
garp join time.
H/H
garptimer leave <leave msec> (STUC mode only) Set system’s
garp leave time.
H/H
garptimer leaveall <leaveall msec> (STUC mode only) Set system’s
garp leaveall time.
H/H
rstp show (STUC mode only) Display the
system’s rstp settings.
M/L
rstp enable (STUC mode only) Turn system’s
rstp on.
H/H
rstp disable (STUC mode only) Turn system’s
rstp off.
H/H
rstp priority <priority> (STUC mode only) Set system
rstp’s priority.
H/H
rstp hellotime <hellotime sec> (STUC mode only) Set system
rstp’s hello time.
H/H
Table 89 Commands (continued)
CLASS COMMAND PARAMETERS DESCRIPTION P