4 acl profile map screen, Pvcs (see – ZyXEL Communications IES-708-22A User Manual
Page 213
Chapter 32 ACL
IES-708-22A User’s Guide
213
32.4 ACL Profile Map Screen
Use this screen to look at all the ACL profiles and the PVCs to which each one is assigned. To
open this screen, click Advanced Application > ACL > ACL Profile Map.
Profile Name
Enter a descriptive name for the ACL profile. The name can be 1-31 printable
English keyboard characters long. Spaces are not allowed.
Rule
Select which type of rule to use.
Note: The lower the number (1-14), the higher the priority the rule
has.
Provide additional information required for the selected rule. Additional rules
consist of one or more of the following criteria.
ethernet type
Enter the 16-bit EtherType value between 0 and 65535.
vlan
Enter a VLAN ID between 1 and 4094.
source mac
Enter the source MAC address.
dest mac
Enter the destination MAC address.
priority
Select the IEEE 802.1p priority.
protocol
Select the IP protocol used.
protocol type
Enter the IP protocol number (between 0 and 255) used.
source ip
Enter the source IP address and subnet mask in dotted decimal notation.
dest ip
Enter the source IP address and subnet mask in dotted decimal notation.
tos
Enter the start and end Type of Service between 0 and 255.
source port
Enter the source port or range of source ports.
dest port
Enter the destination port or range of destination ports.
Action
Select which action(s) the IES-708-22A should follow when the criteria are
satisfied.
rate
Enter the maximum bandwidth this traffic is allowed to have.
replaced vlan
Enter the VLAN ID that this traffic should use.
replaced priority
Select the IEEE 802.1p priority that this traffic should have.
deny
Select this if you want the IES-708-22A to reject this kind of traffic.
ACL Profile List
Index
This field displays a sequential value. The sequence in this table is not
important. Click this to edit the associated ACL profile in the section above.
ACL Profile
This field displays the name of this ACL profile.
Select
Delete
Select the check box in the Select column for an entry, and click Delete to
remove the entry.
Select All
Click this to select all entries in the table.
Select None
Click this to un-select all entries in the table.
Table 70 Advanced Application > ACL > ACL Profile Setup (continued)
LABEL
DESCRIPTION