ZyXEL Communications IES-708-22A - Manual (Page 228)

Chapter 36 Static Routing
IES-708-22A User’s Guide
228
Metric The metric represents the “cost” of transmission for routing purposes. IP routing
uses hop count as the measurement of cost, with a minimum of 1 for directly
connected networks. Enter a number that approximates the cost for this link.
The number need not be precise, but it must be between 1 and 15. In practice, 2
or 3 is usually a good number.
Add Click Add to save the new rule to the IES-708-22A’s volatile memory. It then
displays in the summary table at the bottom of the screen. The IES-708-22A
loses these changes if it is turned off or loses power, so use the Config Save
link on the navigation panel to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Use this section to look at a summary of all static routes in the IES-708-22A.
Previous Page Click this to display the preceding page of static route entries.
Next Page Click this to display the following page of static route entries.
Index This field displays the index number of the route.
Name This field displays the name of this static route.
Destination Address This field displays the IP network address of the final destination.
Subnet Mask This field displays the subnet mask for this destination.
Gateway Address This field displays the IP address of the gateway. The gateway is an immediate
neighbor of your device that will forward the packet to the destination.
Metric This field displays the cost of transmission for routing purposes.
Delete Select the rule(s) that you want to remove in the Delete column, and then click
the Delete button.
Cancel Click Cancel to clear the selected check boxes in the Delete column.
Table 80 Routing Protocol > Static Routing (continued)
LABEL DESCRIPTION