ZyXEL Communications IES-708-22A - Manual (Page 217)

IES-708-22A User’s Guide
217
C
H A P T E R
34
SysLog
This chapter explains how to set the syslog parameters.
34.1 Syslog
The syslog feature sends logs to an external syslog server.
34.2 SysLog Screen
To open this screen, click Advanced Application > SysLog.
Figure 110 Advanced Application > SysLog
The following table describes the labels in this screen.
Table 73 Advanced Application > SysLog
LABEL DESCRIPTION
Enable Unix Syslog Select this check box to activate syslog (system logging) and then configure the
syslog parameters described in the following fields.
Syslog Server IP Enter the IP address of the syslog server. (The log facility is specified in Alarm >
Alarm Event Setup. See Section 37.4 on page 231 .)
Apply Click Apply to save your changes to the IES-708-22A’s volatile memory. The
IES-708-22A loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.