Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 176)

148 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying BGP4 information
As-path attribute
count Shows the count of the AS-path attribute.
Outbound Policy
Group Shows the ID and the count used in the outbound policy group.
TCP Connection
state Shows the state of the connection with the neighbor. The connection can have one of the
following states:
•
LISTEN – Waiting for a connection request.
•
SYN-SENT – Waiting for a matching connection request after having sent a connection
request.
•
SYN-RECEIVED – Waiting for a confirming connection request acknowledgment after
having both received and sent a connection request.
•
ESTABLISHED – Data can be sent and received over the connection. This is the normal
operational state of the connection.
•
FIN-WAIT-1 – Waiting for a connection termination request from the remote TCP, or an
acknowledgment of the connection termination request previously sent.
•
FIN-WAIT-2 – Waiting for a connection termination request from the remote TCP.
•
CLOSE-WAIT – Waiting for a connection termination request from the local user.
•
CLOSING – Waiting for a connection termination request acknowledgment from the
remote TCP.
•
LAST-ACK – Waiting for an acknowledgment of the connection termination request
previously sent to the remote TCP (which includes an acknowledgment of its connection
termination request).
•
TIME-WAIT – Waiting for the specific time to ensure that the remote TCP received the
acknowledgment of its connection termination request.
•
CLOSED – There is no connection state.
Maximum
segment size Shows the TCP maximum segment size.
TTL check Shows the TCP TTL check.
Byte Sent Shows the number of bytes sent.
Byte Received Shows the number of bytes received.
Local host Shows the IPv4 address of the router.
Local port Shows the TCP port that the device is using for the BGP4 TCP session with the neighbor.
Remote host Shows the IPv4 address of the neighbor.
Remote port Shows the TCP port the neighbor is using for the BGP4 TCP session with therouter.
ISentSeq Shows the initial send sequence number for the session.
SendNext Shows the next sequence number to be sent.
TotUnAck Shows the count of sequence numbers sent by the router that have not been acknowledged
by the neighbor.
TotSent Shows the count of the sequence numbers sent to the neighbor.
ReTrans Shows the count of the sequence numbers that the device retransmitted because they were
not acknowledged.
UnAckSeq Shows the current acknowledged sequence number.
IRcvSeq Shows the initial receive sequence number for the session.
RcvNext Shows the next sequence number expected from the neighbor.
TABLE 15 Output parameters of the show ip bgp neighbors command (Continued)
Field Description