Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 310)

282 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
IS-IS Non-Stop Routing
No ISIS Shortcuts Configured
BFD: Disabled
NSR: Enabled
NSR State: Normal
Standby MP: Ready
Sync State: Enabled
Interfaces with IPv4 IS-IS configured:
ethernet 2/1 ve 20 ve 165 loopback 1 loopback 2 loopback 3
The following table describes the output of the show isis command.
TABLE 38 Output from the show isis command
This field... Displays...
IS-IS Routing Protocol Operation State This field indicates the operating state of IS-IS and the possible states
includes the following:
•
Enabled – IS-IS is enabled.
•
Disabled – IS-IS is disabled.
IS-Type This field indicates the intermediate system type and the possible types
includes the following:
•
Level 1 only – The Brocade device routes traffic only within the area
in which it resides.
•
Level 2 only – The Brocade device routes traffic between areas of a
routing domain.
•
Level 1-2 – The Brocade device routes traffic within the area in
which it resides and between areas of a routing domain.
System ID This field indicates the unique IS-IS router ID. Typically, the router base
MAC address is used as the system ID.
Manual area address(es) This field indicates the Area address(es) of the Brocade device.
Level-1-2 Database State This field indicates the state of the Level 1-2 Database:
•
On
•
Off
Administrative Distance This field specifies the current setting of the IS-IS administrative
distance.
Maximum Paths This field specifies the number of paths IS-IS can calculate and install in
the forwarding table.
Default redistribution metric This field specifies the value of the default redistribution metric, which is
the IS-IS cost of redistributing the route into IS-IS.
Number of Routes redistributed into
IS-IS This field specifies the number of routes distributed into IS-IS.
Level-1 Auth-mode This field indicates one of the following authentication modes set for
Level-1 on the router:
•
None
•
md5
•
cleartext
Level-2 Auth-mode This field indicates one of the following authentication modes set for
Level-2 on the router:
•
None
•
md5
•
cleartext