Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 431)

Multi-Service IronWare Routing Configuration Guide 403
53-1003033-02
Displaying the management VRF information
16 closed
Syntax: show who
To display the packets and sessions rejection statistics due to failure in management VRF
validation, enter the following command.
Brocade(config)# show management-vrf
Management VRF name : mvrf
Management Application Rx Drop Pkts Tx Drop Pkts
SNMP Engine 36 0
RADIUS Client 0 8
TFTP Client 0 4
SNMP Notifications - 55
SysLogs - 78
TCP Connection rejects:
Telnet : 1
SSH : 1
TACACS+ Client : 8
Syntax: show management-vrf
Table 69 displays a description of the output from the show management-vrf command.
Make sure that the management VRF is configured before executing the show management-vrf
command. If not, the system will display the following error message.
Error - Management VRF is not configured.
To clear the management VRF rejection statistics, enter the following command.
Brocade(config)# clear management-vrf-stats
Syntax: clear management-vrf-stats
TABLE 69 Output from the show management-vrf command
This field... Displays...
Management VRF name Displays the configured management VRF name.
Management Application Displays the management application names.
Rx Drop Pkts Displays the number of packets dropped in the inbound traffic.
Tx Drop Pkts Displays the number of packets dropped in the outbound traffic.
TCP Connection rejects Displays the number of TCP connections per application rejected
due to management VRF validation.