Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 586)

558 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying BGP4+ information
Syntax: show ipv6 bgp neighbor last-packet-with-error
This display shows the following information.
Displaying Outbound Route Filters received from a BGP4+ neighbor
You can display the Outbound Route Filters (ORFs) received from a BGP4+ neighbor. This option
applies to cooperative route filtering feature.
For example, to display the ORFs received from neighbor 2001:db8::110, enter the following
command.
Syntax: show ipv6 bgp neighbor ipv6-address received prefix-filter
The ipv6-address parameter displays the prefix filter learned from a specified neighbor. You must
specify this address in hexadecimal using 16-bit values between colons as documented in RFC
2373.
Displaying routes received from a BGP4+ neighbor
You can display a summary or detailed route information received in route updates from a specified
BGP4+ neighbor since you enabled the soft reconfiguration feature.
For example, to display a summary of the route information received in route updates from
neighbor 2001:db8::10, enter the following command at any level of the CLI.
TABLE 113 Last error packet information for BGP4+ neighbors
This field... Displays...
Total number of BGP Neighbors The total number of configured neighbors for a device.
Last error The error packet’s contents decoded in a human-readable format or
notification that no packets with an error were received.
Brocade# show ipv6 bgp neighbor last-packet-with-error
Total number of BGP Neighbors: 266
No received packet with error logged for any neighbor
Brocade# show ipv6 bgp neighbor 2001:db8::110 received prefix-filter
ip prefix-list 2001:db8::110: 4 entries
seq 5 permit 2001:db8:3::45/16 ge 18 le 28
seq 10 permit 2001:db8::4::88/24
seq 15 permit 2001:db8:5::37/8 le 32
seq 20 permit 2001:db8:6::83/16 ge 18