Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 829)

Multi-Service IronWare Routing Configuration Guide 801
53-1003033-02
Displaying VRRP and VRRP-E information for IPv4
Syntax: show ip vrrp-extended [brief | ethernet slot/portnum | statistics | ve num | vrid id]
The brief parameter displays the summary information. If you do not use this parameter, detailed
information is displayed instead. Refer to
“Displaying detailed information” on page 802.
The ethernet slot/portnum parameter specifies an Ethernet port. If you use this parameter, the
command displays IPv4 VRRP or VRRP-E information only for the specified port.
The ve num parameter specifies a virtual interface. If you use this parameter, the command
displays IPv4 VRRP or VRRP-E information only for the specified virtual interface.
The vrid id parameter specifies a virtual router ID. If you use this parameter, the command displays
IPv4 VRRP or VRRP-E information only for the specified virtual router.
The statistics parameter displays statistics. Refer to “Displaying statistics” on page 805.
This display shows the following information.
TABLE 171 CLI display of VRRP or VRRP-E summary information
This field... Displays...
Total number of VRRP (or
VRRP-Extended) routers defined The total number of virtual routers configured on this Brocade device.
NOTE: The total applies only to the protocol the Brocade device is
running. For example, if the Brocade device is running VRRP-E,
the total applies only to VRRP-E routers.
Interface The interface on which VRRP or VRRP-E is configured. If VRRP or VRRP-E
is configured on multiple interfaces, information for each interface is
listed separately.
VRID The ID of the virtual router configured on this interface. If multiple virtual
routers are configured on the interface, information for each virtual
router is listed in a separate row.
Current Priority The current VRRP or VRRP-E priority of this Brocade device for the virtual
router.
Flags Whether the backup preempt mode is enabled. If the backup preempt
mode is enabled, this field contains a “P”. If the mode is disabled, this
field is blank.
P:Preempt 2:V2 3:V3
2: implies VRRP Version2
3: implies VRRP Version3.
Short-Path-Fwd Displays information about whether VRRP-E Extension for Server
Virtualization is enabled or disabled.
State This Brocade device’s VRRP or VRRP-E state for the virtual router. The
state can be one of the following:
•
Init – The virtual router is not enabled (activated). If the state
remains Init after you activate the virtual router, make sure that the
virtual router is also configured on the other routers and that the
routers can communicate with each other.
NOTE: If the state is Init and the mode is incomplete, make sure you
have specified the IP address for the virtual router.
•
Backup – This Brocade device is a Backup for the virtual router.
•
Master – This Brocade device is the Master for the virtual router.
Master addr The IP address of the router interface that is currently the Master for the
virtual router.