Neighbor remote-as – Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 630
602
Multi-Service IronWare Routing Configuration Guide
53-1003033-02
neighbor remote-as
neighbor remote-as
Configures the neighbor router in the VPNv6 unicast address family.
Syntax
neighbor ipv4-address remote-as as-number
Command
Default
None
Parameters
ipv4-address
Neighbor IP address
remote-as
Specifies a BGP neighbor
as-number
AS number of a remote neighbor
Command
Modes
Global configuration mode
Usage
Guidelines
The neighbor remote-as command is used to configure neighbor router in VPNv6 unicast address
family. Only IPv4 neighbors are supported.
Examples
The following example explains how to configure neighbor router in VPNv6 unicast address family.
Brocade(config-bgp-vpnv6u)#neighbor 10.0.0.1 remote-as 100
History
Related
Commands
address-family vpnv6
neighbor capability orf
clear ip bgp vpnv6 neighbor
Release
Command History
Multi-Service IronWare R05.5.00 This command was introduced.