Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 784)

756 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying RIPng information
Syntax: show ipv6 rip
This display shows the following information.
TABLE 164 RIPng configuration fields
This field... Displays...
IPv6 RIP status or port The status of RIPng on the device. Possible status is “enabled” or
“disabled.”
The UDP port number over which RIPng is enabled.
Administrative distance The setting of the administrative distance for RIPng.
Updates or expiration The settings of the RIPng update and timeout timers.
Holddown or garbage collection The settings of the RIPng hold-down and garbage-collection timers.
Split horizon or poison reverse The status of the RIPng split horizon and poison reverse features.
Possible status is “on” or “off.”
Default routes The status of RIPng default routes.
Periodic updates or trigger updates The number of periodic updates and triggered updates sent by the
RIPng Brocade device.
Distribution lists The inbound and outbound distribution lists applied to RIPng.
Redistribution The types of IPv6 routes redistributed into RIPng. The types can include
the following:
•
STATIC – IPv6 static routes are redistributed into RIPng.
•
CONNECTED – Directly connected IPv6 networks are redistributed
into RIPng.
•
BGP – BGP4+ routes are redistributed into RIPng.
•
IS-IS – IPv6 IS-IS routes are redistributed into RIPng.
•
OSPF – OSPFv3 routes are redistributed into RIPng.
Brocade# show ipv6 rip
IPv6 rip enabled, port 521
Administrative distance is 120
Updates every 30 seconds, expire after 180
Holddown lasts 180 seconds, garbage collect after 120
Split horizon is on; poison reverse is off
Default routes are not generated
Periodic updates 0, trigger updates 0
Distribute List, Inbound : Not set
Distribute List, Outbound : Not set
Redistribute: CONNECTED