Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 767)

Multi-Service IronWare Routing Configuration Guide 739
53-1003033-02
Displaying IPv6 IS-IS information
To display detailed information about all IPv6 IS-IS neighbors of a device, enter the following
command at any level of the CLI.
This display shows the following information.
State The state of the adjacency with the neighbor. The state can be one of the
following:
•
DOWN – The adjacency is down.
•
INIT – The adjacency is being established and is not up yet.
•
UP – The adjacency is up.
Holdtime The time between transmissions of IS-IS hello messages.
Type The IS-IS type of the adjacency. The type can be one of the following:
•
ISL1 – Level-1 IS
•
ISL2 – Level-2 IS
•
PTP – Point-to-Point IS
•
ES – ES
Note: The device forms a separate adjacency for each IS-IS type. Thus, if the
device has both types of IS-IS adjacencies with the neighbor, the display
contains a separate row of information for each adjacency.
Pri The priority of this IS to be elected as the Designated IS in this broadcast
network.
StateChgeTime The amount of time that has passed since the adjacency last changed state.
TABLE 158 Detailed IPv6 IS-IS neighbor information
This field... Displays...
Total number of IS-IS Neighbors For information about this field, refer to Table 157 on page 738.
System ID For information about this field, refer to Table 157 on page 738.
Interface For information about this field, refer to Table 157 on page 738.
SNPA For information about this field, refer to Table 157 on page 738.
State For information about this field, refer to Table 157 on page 738.
Holdtime For information about this field, refer to Table 157 on page 738.
Type For information about this field, refer to Table 157 on page 738.
Pri For information about this field, refer to Table 157 on page 738.
TABLE 157 Summary of IPv6 IS-IS neighbor information (Continued)
This field... Displays...
Brocade# show ipv6 isis neighbor detail
Total number of IS-IS Neighbors: 2
System ID Interface SNPA State Holdtime Type Pri StateChgeTime
Router1 Ether 3/2 0000.0000.0020 UP 30 ISL2 64 0 :0 :14:5
Area Address(es): 49.6561
IP Address(es): 10.0.0.1
IPv6 Address: fe80::2e0:52ff:fe00:20
Circuit ID: 10.2222.2222.01
System ID Interface SNPA State Holdtime Type Pri StateChgeTime
Router1 Ether 3/2 0000.0000.0020 UP 30 ISL1 64 0 :0 :14:5
Area Address(es): 49.6561
IP Address(es): 10.0.0.1
IPv6 Address: fe80::2e0:52ff:fe00:20
Circuit ID: 10.2222.2222.01