Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 332)

304 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying IPv4 IS-IS information
Displaying detailed information
To display detailed information for all the LSPs in the Brocade device’s LSP databases, enter the
following command at any level of the CLI.
TABLE 45 IS-IS detailed LSP database information
This field... Displays...
LSPID Refer to the description of the summary display.
LSP Seq Num Refer to the description of the summary display.
LSP Checksum Refer to the description of the summary display.
LSP Holdtime Refer to the description of the summary display.
ATT or P or OL Refer to the description of the summary display.
Area Address The address of the area.
NLPID The Network Layer Protocol Identifier (NLPID), which specifies the
protocol the IS that sent the LSP is using. Usually, this value is “CC(IP)”.
IP address The IP address of the interface that sent the LSP. The Brocade device
can use this address as the next hop in routes to the addresses listed in
the rows below.
Brocade# show isis database detail
IS-IS Level-1 Link State Database
LSPID LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
XMR.00-00* 0x0000000b 0x23fb 971 1/0/0
Area Address: 49
NLPID: CC(IP)
Hostname: XMR14
IP Address: 10.1.1.1
IPv6 Address: 2001:db8::14
Metric: 10 IP-Internal 10.1.1.0/24 Up-bit: 0
Metric: 10 IS XMR.01
IS-IS Level-2 Link State Database
LSPID LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
XMR.00-00* 0x0000000d 0x7d97 903 1/0/0
Area Address: 49
NLPID: IPv6IP
Hostname: XMR14
IP address: 10.1.1.1
IPv6 address: 2001:db8::14
Flooding to 1 interface: eth 1/7
Metric: 10 IP-Internal 10.1.1.0/24 Up-bit: 0
Metric: 10 IP-Internal 10.85.1.0/24 Up-bit: 0
Metric: 10 IS XMR.01
Metric: 10 IS XMR.02