Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 417)

Multi-Service IronWare Routing Configuration Guide 389
53-1003033-02
Configuring Inter-VRF routing
Displaying IPv4 routes in VRF one import
To display IP information for a specified VRF import, enter the following command at any level of the
CLI.
Brocade(config)#show ip route vrf one import
Type Codes - B:BGP D:Connected I:ISIS O:OSPF R:RIP S:Static; Cost - Dist/Metric
BGP Codes - i:iBGP e:eBGP
ISIS Codes - L1:Level-1 L2:Level-2
OSPF Codes - i:Inter Area 1:External Type 1 2:External Type 2 s:Sham Link
Destination Gateway Port Cost Type Uptime src-vrf
1 10.0.0.0/8 10.25.104.1 eth1/1 20 O 4d1h c
2 10.1.0.0/16 10.25.103.1 eth2/1 20 O 3d1h b
3 10.40.0.0/8 10.25.105.1 eth2/1 20 O 3d1h default
Displaying outputs routed from other VRF
To display all the other VRFs from where the routes will be imported into this VRF, enter the
following command at any level of the CLI.
Syntax: show ip vrf vrf-name
Brocade#show ip vrf one
VRF one, default RD 1001:11, Table ID 2 IFL ID 131070
Label: 500000, Label-Switched Mode: OFF
IP Router-Id: 10.1.1.2
Interfaces:
e2/8
No Export VPN route-target communities
No Import VPN route-target communities
No import route-map
No export route-map
Address Family IPv4
Max Routes: 5120
Imports routes from VRF: a, b, c, d
No Export VPN route-target communities
No Import VPN route-target communities
Address Family IPv6
Max Routes: 128
Imports routes from VRF: a, b
No Export VPN route-target communities
No Import VPN route-target communities
Configuring routes from multiple VRFs
This example shows the sequence of commands in configuring routes from multiple VRFs.
Brocade# vrf a
Brocade# rd 1111:11
Brocade# address-family ipv4
Brocade# import routes vrf b route-map import-map
Brocade# import routes vrf c route-map import-map
Brocade# exit-address-family
Brocade# address-family ipv6
Brocade# import routes vrf b route-map import-v6map
Brocade# exit-address-family
Brocade# exit-vrf