Displaying ipsec configuration for an area – Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 724
Advertising
696
Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying OSPFv3 information
Syntax: show ipsec statistics
This command takes no parameters.
Displaying IPsec configuration for an area
The show ipv6 ospf area [area-id] command includes information about IPsec for one area or all
areas. In the following example, the IPsec information is in bold. IPsec is enabled in the first area
(area 0) in this example but not in area 3. Note that in area 3, the IPsec key was specified as not
encrypted.
Advertising