Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 707)

Multi-Service IronWare Routing Configuration Guide 679
53-1003033-02
Displaying OSPFv3 information
eth 2/2 is up, type POINT-TO-POINT
IPv6 Address:
2001:db8:22:22::1/64
2001:db8:22:22::/64
2001:db8:202:202::1/64
2001:db8:202:202::/64
Instance ID 0, Router ID 10.1.1.1
Area ID 100, Cost 1
State P2P, Transmit Delay 1 sec, Priority 1
Timer intervals:
Hello 10, Hello Jitter 10 Dead 40, Retransmit 5
Authentication: Enabled
KeyRolloverTime(sec): Configured: 30 Current: 0
KeyRolloverState: NotActive
Outbound: SPI:11022, ESP, SHA1
Key:1234567890123456789012345678901234567890
Inbound: SPI:11022, ESP, SHA1
Key:1234567890123456789012345678901234567890
DR:0.0.0.0 BDR:0.0.0.0 Number of I/F scoped LSAs is 2
.......................................
You can display detailed OSPFv3 information about a specific interface using the following
command at any level of the CLI.
Syntax: show ipv6 ospf interface [ ethernet slot/port | loopback number | tunnel number | ve
number ]
This display shows the following information.
TABLE 136 Detailed OSPFv3 interface information
This field... Displays...
Interface status The status of the interface. Possible status includes the following:
•
Up.
•
Down.
Type The type of OSPFv3 circuit running on the interface. Possible types include the
following:
•
BROADCAST
•
POINT TO POINT UNKNOWN
•
POINT TO POINT
IPv6 Address The IPv6 address assigned to the interface.
Instance ID An identifier for an instance of OSPFv3.
Router ID The IPv4 address of the device. By default, the router ID is the IPv4 address
configured on the lowest numbered loopback interface. If the device does not
have a loopback interface, the default router ID is the lowest numbered IPv4
address configured on the device.
Area ID The IPv4 address or numerical value of the area in which the interface belongs.
Cost The overhead required to send a packet through the interface.
default Shows whether or not the default passive state is set.