Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 451)

Multi-Service IronWare Routing Configuration Guide 423
53-1003033-02
IPv6 Non stop routing and graceful restart
The restart-time command is used to configure the maximum restart time advertised to neighbors
in seconds. The stale-routes-time command is used to configure the maximum wait time in
seconds for BGP EOR marker.
Show commands
Show running-configuration
This command shows the running configuration.
Brocade#show running-config
Current BGP configuration:
router bgp
local-as 200
neighbor 2001:DB8:22::6 remote-as 100
address-family ipv4 unicast
graceful-restart stale-routes-time 100
graceful-restart purge-time 100
graceful-restart
no neighbor 2001:DB8:22::6 activate
exit-address-family
address-family ipv4 multicast
exit-address-family
address-family ipv6 unicast
graceful-restart restart-time 160
graceful-restart stale-routes-time 120
graceful-restart purge-time 120
graceful-restart
neighbor 2001:DB8:22::6 activate
exit-address-family
address-family ipv6 multicast
exit-address-family
address-family l2vpn vpls
exit-address-family
end of BGP configuration
Show ipv6 bgp neighbors IP address
This command shows the running configuration.
Brocade#show ipv6 bgp neighbors 2001:DB8:22::6
1 IP Address: 2001:DB8:22::6, AS: 100 (EBGP), RouterID: 10.6.6.6, VRF:
default-vrf
State: ESTABLISHED, Time: 2h24m36s, KeepAliveTime: 60, HoldTime: 180
KeepAliveTimer Expire in 16 seconds, HoldTimer Expire in 142 seconds
Minimal Route Advertisement Interval: 0 seconds
RefreshCapability: Received
GracefulRestartCapability: Sent
Restart Time 160 sec, Restart bit 0
afi/safi 2/1, Forwarding bit 0
Messages: Open Update KeepAlive Notification Refresh-Req
Sent : 1 1 164 0 0