Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 616)

588 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying BGP4+ information
Displaying BGP4+ VRF6 peer group information
To view BGP4+ VRF6 peer group information for a specified VRF6, enter the following command.
Syntax: show ipv6 bgp vrf vrf-name peer-group
The vrf-name parameter specifies the VRF6 name whose nexthop information needs to be
displayed.
Displaying BGP4+ VRF6 route information
To display route information for all the VRF6 routes in the device’s BGP4+ route table, enter the
following command.
Brocade(config-bgp-ipv6u-vrf)#show ipv6 bgp vrf 2 peer-group pg1
1 BGP peer-group is pg1, Remote AS: 200
Address family : IPV4 Unicast
no activate
DefaultOriginate: yes
Address family : IPV4 Multicast
no activate
Address family : IPV6 Unicast
activate
Address family : IPV6 Multicast
no activate
Address family : VPNV4 Unicast
no activate
Address family : VPNV6 Unicast
no activate
Address family : L2VPN VPLS
no activate
Members:
IP Address: 2::2
IP Address: 11::2, AS: 300