Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 220)

192 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Configuring OSPF
The always parameter advertises the default route regardless of whether the router has a default
route. This option is disabled by default.
The metric value parameter specifies a metric for the default route. If this option is not used, the
default metric is used for the route.
The metric-type type parameter specifies the external link type associated with the default route
advertised into the OSPF routing domain. The type can be one of the following:
• type1 – Type 1 external route
• type2 – Type 2 external route
If you do not use this option, the default redistribution metric type is used for the route type.
NOTE
If you specify a metric and metric type, the values you specify are used even if you do not use the
always option.
The route-map parameter overrides other options. If set commands for metric and metric-type are
specified in the route-map, the command-line values of metric and metric-type if specified, are
ignored” for clarification.
The route-map rmap parameter specifies the route map reference.
The corresponding route-map should be created before configuring the route-map option along
with the default-information-originate. If the corresponding route-map was not been created
beforehand, then the an error message will be displayed stating that the route-map must be
created.
NOTE
The route-map option cannot be used with a non-default address in the match conditions. The
default-route LSA shall not be generated if a default route is not present in the routing table and a
match ip address condition for an existing non-default route is configured in the route-map. The
match ip-address command in the route-map is a no-op operation for the default information
originate command.
Supported match and set conditions
Table 19 and Table 20 list the supported match and set conditions of a normal route-map
configuration:
TABLE 19 Match Conditions
Match Conditions
ip nexthop prefix-list prefixList
ip nexthop accessList
interface interfaceName
metric metricValue
tag routeTagValue
protocol-type protocol route type and (or) sub-type value
route-type route type (IS-IS sub-type values)