Displaying ipsec for an interface – Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual

Page 727

Advertising
background image

Multi-Service IronWare Routing Configuration Guide

699

53-1003033-02

Displaying OSPFv3 information

Displaying IPsec for an interface

To see IPsec configuration for a particular interface or all interfaces, use the show ipv6 ospf
interface command as in the following example (IPsec information in bold).

Syntax: show ipv6 ospf interface [ethernet slot/port | loopback number | tunnel number | ve

number]

TABLE 149

Area configuration of IPsec

This field...

Displays...

Authentication

This field shows whether or not authentication is configured. If this field says
“Not Configured,” the IPsec-related fields (bold in example screen output) are
not displayed at all.

KeyRolloverTime

The number of seconds between each initiation of a key rollover. This field
shows the configured and current times.

KeyRolloverState

Can be:
Not active: key rollover is not active.
Active phase 1: rollover is in its first interval.
Active phase 2: rollover is in its second interval.

Brocade#show ipv6 ospf interface

eth 1/3 is down, type BROADCAST

Interface is disabled

eth 1/8 is up, type BROADCAST

IPv6 Address:

2001:db8:18:18:18::1/64

2001:db8:18:18::/64

Instance ID 255, Router ID 10.1.1.1

Area ID 1, Cost 1

State BDR, Transmit Delay 1 sec, Priority 1

Timer intervals :

Hello 10, Hello Jitter 10 Dead 40, Retransmit 5

Authentication: Enabled

KeyRolloverTime(sec): Configured: 30 Current: 0

KeyRolloverState: NotActive

Outbound: SPI:121212, ESP, SHA1

Key:1234567890123456789012345678901234567890

Inbound: SPI:121212, ESP, SHA1

Key:1234567890123456789012345678901234567890

DR:10.2.2.2 BDR:10.1.1.1 Number of I/F scoped LSAs is 2

DRElection: 1 times, DelayedLSAck: 83 times

Neighbor Count = 1, Adjacent Neighbor Count= 1

Neighbor:

10.2.2.2 (DR)

Statistics of interface eth 1/8:

Type tx rx tx-byte rx-byte

Unknown 0 0 0 0

Hello 1415 1408 56592 56320

DbDesc 3 3 804 804

LSReq 1 1 28 28

LSUpdate 193 121 15616 9720

LSAck 85 109 4840 4924

OSPF messages dropped,no authentication: 0

Advertising