Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 600)

572 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying BGP4+ information
Displaying BGP4+VPNv6 neighbor information
To view BGP4+ configuration information and statistics for IPv4 neighbors with VPNv6 capability
negotiated, enter the following command.
Syntax: show ip bgp vpnv6 neighbors
Table 122 provides information about the command’s output.
TABLE 122 BGP4+ VPNv6 neighbor information
This field... Displays...
IP Address The IP address of the neighbor.
AS The AS the neighbor is in.
EBGP or IBGP Whether the neighbor session is an IBGP session, an EBGP session, or
a confederation EBGP session:
•
EBGP – The neighbor is in another AS.
•
EBGP_Confed – The neighbor is a member of another sub-AS in
the same confederation.
•
IBGP – The neighbor is in the same AS.
RouterID The neighbor’s ID.
Brocade(config-bgp-vpnv4u)#show ip bgp vpnv6 neighbors
1 IP Address: 40.0.0.4, AS: 100 (IBGP), RouterID: 4.4.4.4, VRF:
default-vrf
State: ESTABLISHED, Time: 0h4m1s, KeepAliveTime: 60, HoldTime: 180
KeepAliveTimer Expire in 31 seconds, HoldTimer Expire in 149 seconds
Minimal Route Advertisement Interval: 0 seconds
RefreshCapability: Received
Address Family : VPNV6 Unicast
SendExtenedCommunity: yes
Messages: Open Update KeepAlive Notification Refresh-Req
Sent : 1 0 5 0 0
Received: 1 0 5 0 0
Last Update Time: NLRI Withdraw NLRI Withdraw
Tx: --- --- Rx: --- ---
Last Connection Reset Reason:Unknown
Notification Sent: Unspecified
Notification Received: Unspecified
Neighbor NLRI Negotiation:
Peer Negotiated VPNv6 unicast capability
Peer configured for VPNv6 unicast Routes
Neighbor ipv6 MPLS Label Capability Negotiation:
Neighbor AS4 Capability Negotiation:
Outbound Policy Group:
ID: 6, Use Count: 1
TCP Connection state: ESTABLISHED, flags:00000033 (0,0)
Maximum segment size: 1460
TTL check: 0, value: 0, rcvd: 64
Byte Sent: 140, Received: 140