Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 764)

736 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying IPv6 IS-IS information
TABLE 155 IPv6 IS-IS interface information
This field... Displays...
Total number of IS-IS interfaces The number of interfaces on which IPv6 IS-IS is enabled.
Interface The port or virtual interface number to which the information listed below
applies.
Local Circuit Number The ID that the instance of IPv6 IS-IS running on the interface applied to the
circuit between this interface and the interface at the other end of the link.
Circuit Type The type of IS-IS circuit running on the interface. The circuit type can be one of
the following:
•
BCAST– broadcast
•
PTP – point-to-point
Circuit Mode The IS-IS type in use on the circuit. The mode can be one of the following:
•
LEVEL-1
•
LEVEL-2
•
LEVEL-1-2
Circuit State The state of the circuit, which can be one of the following:
•
DOWN
•
UP
Passive State The state of the passive option, which determines whether the interface is
allowed to form an IS-IS adjacency with the IS at the other end of the circuit.
The state can be one of the following:
•
FALSE – The passive option is disabled. The interface can form an
adjacency with the IS at the other end of the link.
•
TRUE – The passive option is enabled. The interface cannot form an
adjacency, but can still advertise itself into the area.
MTU The maximum length supported for IS-IS PDUs sent on this interface.
Level-1 Metric The default-metric value that the device inserts in IS-IS Level-1 PDUs originated
on this interface.
Level-1 Priority The priority of this IS to be elected as the Designated IS for Level-1 in this
broadcast network.
Level-1 Hello Interval The number of seconds the software waits between sending Level-1 hello
PDUs to the IS at the other end of the circuit.
Level-1 Hello Multiplier The number by which the software multiplies the hello interval to calculate the
hold time for Level-1 Hello messages received on the circuit.
Level-1 Designated IS The NET of the Level-1 Designated IS.
Level-1 DIS Changes The number of times the NET of the Level-1 Designated IS has changed.
Level-2 Metric The default-metric value that the device inserts in IS-IS Level-2 PDUs originated
on this interface.
Level-2 Priority The priority of this IS to be elected as the Designated IS for Level-2 in this
broadcast network.
Level-2 Hello Interval The number of seconds the software waits between sending Level-2 Hello
messages to the IS at the other end of the circuit.
Level-2 Hello Multiplier The number by which the software multiplies the hello interval to calculate the
hold time for Level-2 LSPs received on the circuit.
Level-2 Designated IS The NET of the Level-2 Designated IS.
Level-2 DIS Changes The number of times the NET of the Level-2 Designated IS has changed.