Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 312
284
Multi-Service IronWare Routing Configuration Guide
53-1003033-02
IS-IS Non-Stop Routing
Second-wait
This fields indicates the wait time between the first and second PSPF
calculations. If this optional value is configured, it will be doubled with
each PSPF recalculation until the value is equal to the max-wait value
This value reflects the second-wait variable that is configured using the
partial-spf-interval command as described in
PSPF run status.
This field is not specifically labeled but it is displayed directly under the
PSPF timers. It can be any of the three values shown below:
•
PSPF is running
•
PSPF will run in sec where the sec variable is a value in seconds
until the next time that PSPF will be run.
•
PSPF is not scheduled
Timers: LSP:
max-lifetime
This fields indicates the maximum number of seconds an unrefreshed
LSP can remain in the Brocade device’s LSP database.
The default value is 1000 sec.
refresh-interval
This fields indicates the maximum number of seconds that a Brocade
device waits between sending updated LSPs to its IS-IS neighbors.
The default value is 1 sec.
gen-interval
This fields indicates the minimum number of seconds that a Brocade
device waits between sending updated LSPs to its IS-IS neighbors.
The default value is 10 sec.
retransmit-interval
This fields indicates the amount of time the Brocade device waits before
it retransmits LSPs.
The default value is 5 sec.
lsp-interval
This fields indicates the rate of transmission (in milliseconds) of the
LSPs.
The default rate is 33 ms.
Timers: SNP:
csnp-interval
This fields indicates how often the designated IS sends a CSNP to the
broadcast interface.
The default value is 10 sec.
psnp-interval
This fields indicates how often the IS sends a PSNP.
The default value is 2 sec.
Global Hello Padding
The value can be:
•
Enabled
•
Disabled
Global Hello Padding For Point to Point
Circuits
The value can be:
•
Enabled
•
Disabled
Ptpt Three Way HandShake Mechanism The value can be:
•
Enabled
•
Disabled
IS-IS Traffic Engineering Support
The value can be:
•
Enabled
•
Disabled
TABLE 38
Output from the show isis command (Continued)
This field...
Displays...