Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 411
Multi-Service IronWare Routing Configuration Guide
383
53-1003033-02
Features & benefits
FIGURE 31
Inter-VRF routing topology
To import routes from multiple VRFs, multiple import commands need to be defined. The filtering
criteria for routes to be imported are specified using route-maps by the user. Routes can be filtered
based on BGP attributes, interfaces, IP addresses, next hops, metrics, metric types, protocols,
route types and tags which are supported by our existing route-map infrastructure.
Routes from multiple (default 50) VRFs can be selectively imported into a target destination VRF.
Imported routes can be redistributed using routing protocols.
Configuring IPv6 inter-VRF routing is very similar to configuring inter-VRF routing for IPv4. The
behavior and CLI syntax of route-maps is the same between IPv4 and IPv6 address families.
The route-map attributes that are used for filtering the routes are: