Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 499)

Multi-Service IronWare Routing Configuration Guide 471
53-1003033-02
Displaying global IPv6 information
Syntax: show ipv6 route nexthop nexthop_id
The nexthop_id is under the column labeled ID in the output of the show ip route nexthop
command. In the following example, the output of the show ip route nexthop command is displayed
for a nexthop ID 65538.
Displaying IPv6 routes with nexthop ID
By using the nexthop option with the ref-routes keyword, you can display IPv6 routes in the
forwarding table that refer to a specified nexthop entry, as the following example illustrates (using
nexthop ID 65538).
Syntax: show ipv6 route nexthop nexthop_id ref-routes
Description of command output fields
The following table lists the information in the show ipv6 route command output when you run the
show ipv6 route nexthop nexthop_id ref-routes command.
This display shows the following information.
Brocade# show ipv6 route nexthop
Total number of IPv6 nexthop entries: 261; Forwarding Use: 259
NextHopIp Port RefCount ID Age
1 :: eth 1/2 1/1 1 973
2 :: drop 1/1 65536 1013
5 :: ve 257 1/1 898 973
6 :: ve 279 1/1 920 973
7 :: ve 299 1/1 940 973
8 192::1 eth 1/2 255959/255960 65538 1109
…
Brocade# show ipv6 route nexthop 65538
NextHopIp Port RefCount ID Age
1 192::1 eth 1/2 255950/255951 65538 1384
Brocade#show ipv6 route nexthop 65538 ref-routes
Type Codes - B:BGP D:Connected I:ISIS O:OSPF R:RIP S:Static; Cost - Dist/Metric
ISIS Codes - L1:Level-1 L2:Level-2
OSPF Codes - i:Inter Area 1:External Type 1 2:External Type 2 s:Sham Link
Destination Gateway Port Cost Type Uptime
1 3::/64 300:300::2 eth 1/2 20/0 B 15m27s
2 4::/64 300:300::2 eth 1/2 20/0 B 18m17s
3 4:21:103::0/126 300:300::2 eth 1/2 20/0 B 15m48s
4 4:23:112::0/126 300:300::2 eth 1/2 20/0 B 19m12s
5 4:23:113::0/126 300:300::2 eth 1/2 20/0 B 19m12s
6 4:23:114::0/126 300:300::2 eth 1/2 20/0 B 19m12s