Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 625)

Multi-Service IronWare Routing Configuration Guide 597
53-1003033-02
address-family vpnv6 unicast
address-family vpnv6 unicast
Configures the IPv6 address family and allows BGP peers to accept the address family-specific
configuration.
Syntax address-family vpnv6 unicast
Command
Default
None
Parameters None
Command
Modes
BGP interface configuration mode
Usage
Guidelines
The address-family vpnv6 unicast command is used to configure the IPv6 address family and for
BGP peers to accept address family specific configuration.
Examples The following example explains how to configure address-family for vpnv6 unicast.
Brocade(config-bgp)#address-family vpnv6 unicast
Brocade(config-bgp-vpnv6u)#?
address-family Enter Address Family command mode
bfd Set BFD global parameters for BGP4
bfd-enable Enable BFD for BGP4
clear Clear table/statistics/keys
cls Clear screen
end End Configuration level and go to Privileged
level
exit Exit current level
exit-address-family Exit Address Family command mode
neighbor Specify a neighbor router
no Undo/disable commands
quit Exit to User level
rr-group Partition the network by forming RR groups
show Display system information
write Write running configuration to flash or terminal
Related
Commands
neighbor ipv4-address remote-as as-number activate
neighbor capability orf
clear ip bgp vpnv6 neighbor
Release Command History
Multi-Service IronWare R05.5.00 This command was introduced.