Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 86)

58 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Configuring BGP4 neighbors
To display IPv6 unicast router information with respect to the IPv4 neighbor, enter the show ip bgp
ipv6 neighbors command:
R1(config-bgp)#show ip bgp ipv6 neighbors
Total number of BGP Neighbors: 1
1 IP Address: 192.168.1.2, AS: 2 (EBGP), RouterID: 10.1.1.2, VRF: default-vrf
State: ESTABLISHED, Time: 0h8m33s, KeepAliveTime: 60, HoldTime: 180
KeepAliveTimer Expire in 17 seconds, HoldTimer Expire in 135 seconds
UpdateSource: Loopback 1
RefreshCapability: Received
…….
Neighbor NLRI Negotiation:
Peer Negotiated IPV6 unicast capability
Peer configured for IPV6 unicast Routes
Neighbor ipv6 MPLS Label Capability Negotiation:
Neighbor AS4 Capability Negotiation:
TCP Connection state: ESTABLISHED, flags:00000033 (0,0)
Syntax: show ip bgp ipv6 neighbors
[last-packet-with-error]
[routes-summary]
[x.x.x.x]
The neighbors parameter provides details on TCP and BGP neighbor connections.
The last-packet-with-error parameter displays the last packet received with error.
The routes-summary parameter displays the routes summary.
The x.x.x.x parameter is the neighbor IP address. The following sub-parameters are available for the
x.x.x.x parameter:
[advertised routes}
[flap-statistics]
[last-packet-with-error]
[received]
[received-routes]
[rib-out-routes]
[routes]
[routes-summary]
The advertised-routes parameter displays routes advertised to a neighbor.
The flap-statistics parameter displays flap statistics for a neighbor.
The last-packet-with-error parameter displays the last packet received with error.
The received parameter displays the received ORF from neighbor.
The received-routes parameter displays the received routes from neighbor.
The rib-out-routes parameter displays RIB-out routes for a neighbor.
The routes parameter displays routes learned from neighbor.
The routes-summary parameter displays routes summary for a neighbor.