Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 326)

298 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying IPv4 IS-IS information
IPv6 Enabled: TRUE
IPv6 Addresses:
1000::1/32
IPv6 Link-Local Addresses:
fe80::200:ff:fe02:c000
MPLS TE Enabled: FALSE
The following is an example of the show isis interface command for a POS Interface module
configured with a Circuit Type: PTP.
Brocade#show isis interface
Total number of IS-IS Interfaces: 1
Interface: eth 1/1
Circuit State: UP Circuit Mode: LEVEL-1-2
Circuit Type: PTP Passive State: FALSE
Circuit Number: 0x01, MTU: 1500
Level-1 Auth-mode: None
Level-1 Metric: 10
Level-1 Hello Interval: 5 Level-1 Hello Multiplier: 3
Level-2 Metric: 10
Circuit State Changes: 1 Circuit Adjacencies State Changes: 0
Rejected Adjacencies: 0
Circuit Authentication L1 failures: 0
Bad LSPs: 0
Control Messages Sent: 9 Control Messages Received: 1
Hello Padding: Enabled
IP Enabled: TRUE
IP Addresses:
10.1.1.2/24
IPv6 Enabled: TRUE
IPv6 Addresses:
1000::1/32
IPv6 Link-Local Addresses:
fe80::200:ff:fe02:c000
MPLS TE Enabled: FALSE
Syntax: show isis interface [brief | ethernet slot-number/port-number | pos
slot-number/port-number | loopback number | ve number]
This display shows the following information.
TABLE 42 IS-IS interface information
This field... Displays...
Total number of IS-IS interfaces The number of interfaces on which IS-IS is enabled.
Interface The port or virtual interface number to which the information listed
below applies.
Circuit State The state of the circuit, which can be one of the following:
•
DOWN
•
UP
Circuit Mode The IS-IS type in use on the circuit. The mode can be one of the
following:
•
LEVEL-1
•
LEVEL-2
•
LEVEL-1-2