Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 421
Multi-Service IronWare Routing Configuration Guide
393
53-1003033-02
Modified CLI commands
1. OSPF->OSPF
a. route-map option
2. BGP->BGP
a. route-map option
b. Metric option
3. RIP->RIP
a. route-map option
b. Metric option
•
IPv6
1. OSPF->OSPF
a. route-map option
Prior to this release in non-default VRF, redistribution of BGP, RIP and IS-IS routes into OSPFv3 is
not supported. Similarly, in non-default VRF redistribution of IS-IS routes into BGP is also not
supported.
This support is added during the implementation of this feature Inter-vrf Routing.
OSPF and OSPFv3 use default value, while advertising the redistributed routes in their LSA, if the
metric was not configured either in route-map or by metric CLI configuration. The default value is
10 for OSPF and 0 for OSPFv3.
NOTE
BGP IPv6 and RIPng cannot be enabled in a VRF.