ADC Release 3.1 - Manual (Page 137)

1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2-117

2000, ADC Telecommunications, Inc.
DLP-716
Page 1 of 2
VIEW FIBER BANDWIDTH USAGE
Summary: This procedure details the steps required to successfully utilize the NMIC GUI
software to view the used bandwidth on a given fiber link between nodes. This procedure can be
used to check for available bandwidth when assigning new connections. This procedure assumes
the administrator has successfully accessed and launched the NMIC GUI software per NTP-015.
1. To view the bandwidth used between all nodes in the network, use the left mouse button to
select Configuration, Connection, and View Fiber Bandwidth Usage, (or using the direct
selection keys, Alt+C, Alt+N, then Alt+F). Refer to
Figure 716-1 .
2. The Cellworx Vision Fiber Bandwidth Usage window appears. Refer to Figure 716-2 . The
information displayed lists all NEs discovered on the ring, the NEs that they are connected
to, and the amount of bandwidth (in Kbps) assigned between them on the ring.
3. To view the bandwidth being utilized between two individual nodes within the network, use
the right mouse button and point and click on the fiber link between the two nodes. Again,
the pop-up window Fiber Bandwidth Usage appears. displaying the bandwidth usage on the
fiber selected between the two nodes. The values provided in this window are measured in
kilobits per second (Kbps).
3. Select Close to return to the Cellworx Vision network display.
Stop! You have completed this procedure.
Cellworx Vision Subnetwork Management System
File Configuration Fault Performance Help
Software
NMIC Platform
Topology
Time and Date
Connection
GNE-1
Create...
View Fiber Bandwidth Usage ...
View Ring Resource Usage ...
Configure Service Provider Profile ...
Configure Traffic Contract ...
View ...
10962-F
Figure 716-1. Cellworx Vision View Fiber Bandwidth Usage Pull Down Menu