ADC Release 3.1 - Manual (Page 406)

1152700 • Issue 1 • February 2001 • Operation and Maintenance
Page 2-386
© 2000, ADC Telecommunications, Inc.
DLP-788
Page 1 of 3
RETRIEVE FT1 FRS CARD STATUS
Summary: This procedure defines the information retrieved from the shelf level GUI display for
the FT1 FRS card status. User must have the GUI launched and accessed the shelf level GUI
display per NTP-007 prior to performing this procedure.
1. Double click on the FT1 FRS card located in the shelf level GUI “Chassis View” at the top
of the window.
2. The FT1 FRS card display appears as shown in Figure 788-1. Click the small block
between the Status and Configuration sections and drag it downward to view all the status
information. Refer to Table 788-1 for definitions of status information provided.
3. Select each port on the card to view the port status.
4. Select Close button to return to the chassis level view.
Stop! You have completed this procedure.
Cellworx Vision: Card View - T1 Cell Emulation Service
Status:
Apply Chassis View Refresh Close
X
Card Level
Operational State:
Availability State:
Protection State:
Port Level
NE Name: Cellworx1
NE Id: 1
Card: T1 MULTI 1
Slot Number: 8
Port Number: 1
Status
Active
APS
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Port
ADC
T1 MULTI
1
Up
Availabli
Not Protected
Line State:
Receive:
No Alarm
RCV AIS
RCV Far End LOF
RCV Test Code
Transmit:
Xmt AIS
XMT Far End LOF
Other:
LOF
LOS
Loopback State
Other Failure
TC Alarm Status: LCD Alarm
Configuration:
Port Level
APPLIES CHANGES
AND SENDS TO SHELF
CONTROLLER. RETURNS TO CHASSIS
VIEW WITHOUT CLOSING
CARD LEVEL VIEW. REPAINTS WINDOW
TO REFLECT ANY
CHANGES. CLOSES CARD LEVEL
VIEW AND RETURNS TO
SHELF LEVEL VIEW.
CLICK ON BOX AND DRAG
UP OR DOWN TO EXPAND
STATUS OR CONFIGURATION
VIEWS.
13449-B
Figure 788-1. FT1 FRS Card Status Window