ADC Release 3.1 User Manual
Page 44
ADCP-70-220
•
Issue 1
•
November 2000
•
Section 2 Operation and Maintenance
Page 2-14
© 2000, ADC Telecommunications, Inc.
NTP-006
Page 1 of 5
PROVISION NODE PARAMETERS
Summary: This procedure outlines the steps required to assign operational and administrative
parameters within each node such as Node ID, port addresses, card configurations, etc., using the
shelf level Graphical User Interface (GUI) available with Phase 3.1 software. This procedure is
divided into the following headings:
A.
Shelf Parameters
B.
Card Configurations
C.
Card Performance Monitoring Parameters
Pre-requisites to this procedure are:
•
User must be logged into the system and have GUI launched
•
Node to be provisioned must be Discovered and visible to the GUI
Note: In a 19-inch shelf, slot 12 through 15 will always show up as “grayed out” and the
last three slots will always be treated as slots 16, 17, and 18 even though there are
physically only 14 slots available.
A. SHELF PARAMETERS
1.
From the GUI main window, double click on the node to be
provisioned using the left mouse button. This will launch a
session with the node producing a chassis view similar to the
one shown in Figure 006-1.