ADC Release 3.1 - Manual (Page 255)

1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2-235
© 2000, ADC Telecommunications, Inc.
DLP-751
Page 2 of 3
Cellworx Vision: Card View - 622 Ring Interface Card
Status:
Apply Chassis View Refresh
Status
Active
Protect
Timing
Close
X
Configuration:
Card Level
Administrative State: Congestion Thresholds:
Locked
Unlocked
Ingress:
Egress:
80
80
%
%
Port Level
Administrative State: Transmit Timing Source:
Locked
Unlocked
System
Recieved
NE Name: Cellworx1
NE Id: 1
Card: 622 Ring
Slot Number: 17
Port Number: 1
Port
ADC
622
Ring
1
Status
Active
Timing
Do not use for synchronization
SONET
Medium Type:
SDH
Loopback towards:
None Terminal Facility
Diagnostics
Line Coding:
Line Type:
sonetMediumNRZ
sonetLongSingleMode
APPLIES CHANGES
AND SENDS TO SHELF
CONTROLLER. RETURNS TO CHASSIS
VIEW WITHOUT CLOSING
CARD LEVEL VIEW. REPAINTS WINDOW
TO REFLECT ANY
CHANGES. CLOSES CARD LEVEL
VIEW AND RETURNS TO
SHELF LEVEL VIEW. PERFORMS TEST
OVER FIBER
LINK.
CLICK ON BOX AND DRAG
UP OR DOWN TO WIDEN
STATUS OR CONFIGURATION
VIEWS.
CLICK ON BOX AND DRAG UP
OR DOWN TO WIDEN PORT
LEVEL VIEW.
USE SLIDERS TO VIEW
HIDDEN SELECTIONS.
622 MBPS PORT LEVEL
CONFIGURATION OPTIONS.
CARD LEVEL
CONFIGURATION OPTIONS.
NE AND CARD TYPE/
SLOT INFORMATION.
CARD REPRESENTATION
WITH REAL-TIME ALARM
INDICATIONS.
13443-B
Ring Selection :
Auto Ring 16 Ring 17
Enable signal degrade
Signal Degrade BER Threshold: 10E- 5
Figure 751-1. 622 RIC Shelf Level GUI Configuration Screen
Table 751-1. 622 RIC Card Configuration Options
SELECTION DEFAULT OPTIONS DEFINITION
Admin State Unlock N/A Not Configurable on RIC
Congestion
Threshold 80 0-100 Percentage of buffer capacity that will cause a
congestion threshold notification for Ingress and Egress.
Ring
Selection Auto N/A Not Configurable on RIC
Transmit
Timing
Source System System
Received
Uses Primary timing reference.
Uses clock derived from incoming receive fiber (also
known as Line-Timing).
Do Not Use
for Sync False Selected
(true)
Not selected
(false)
If “True”, causes the RIC to output DUS (Do not Use for
Sync) in the S1 byte of the SONET overhead.
Enable Signal
Degrade Not Selected Selected
Not Selected
Enables a protection switch of the traffic if the input
signal strength drops below tolerable levels set by the
user in the BER threshold selection.
(continued)