ADC Release 3.1 - Manual (Page 250)

1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2-230
© 2000, ADC Telecommunications, Inc.
DLP-749
Page 2 of 3
Cellworx Vision: Timing Resource
Apply Chasis View Refresh Close
X
Node Name: Cellworx1
Node Id: 1
Primary: DS1 Output Source
Timing Reference:
Secondary:
None
Enable
APPLIES CHANGES
AND SENDS TO SHELF
CONTROLLER. RETURNS TO CHASSIS
VIEW WITHOUT CLOSING
CURRENT WINDOW. REPAINTS WINDOW
TO REFLECT ANY
CHANGES. CLOSES CARD LEVEL
VIEW AND RETURNS TO
CHASSIS LEVEL VIEW.
13482-C
Status:
Current Timing Reference:
Protection Status:
Active Sync Status:
Alternate Sync Status:
Primary
Enabled
ST3
ST3
Configuration:
TX Sync Status:
FDL Receive:
Frame Format:
Encoding Rule:
Slot 16
N/A
Enabled Disab
N/A ESF S
N/A BSF A
DS1 Output Source:
DS1 Transmit Mode:
AIS Threshold: N/A
N/A
None
Protection:
Switch Command:
Revertive
Non Revertive
Manual
Protection Mode: Revert Time:
0
Figure 749-2. Shelf Level GUI Timing Resource Configuration Window
Table 749-1. Timing Resource Configuration Options
SELECTION
(PRIMARY OR SECONDARY)
DEFAULT OPTIONS DEFINITIONS
Timing Reference Internal BITS Primary
BITS Secondary
Internal
Slot XX
Hardwired in at SC EIM at CO.
Hardwired in at SC EIM at CO.
Uses internal Stratum 3 source.
Uses any optical interface, DS3 running in
PLCP mode, or an E1 card (XX=slot#).
DS1 Output Source None Slot XX
None
Derives a T1 from a received optical signal
of slot specified (XX=slot#).
No source selected for output.
TX Sync Status N/A PRS
ST2
ST3
SMC
DUS
Primary Reference Source
Stratum 2 level source
Stratum 3 level source
SONET Minimum level Clock
Reference should not be used for
source.
(continued)