ADC Release 3.1 - Manual (Page 337)

1152700 • Issue 1 • February 2001 • Section 2 Operations and Maintenance
Page 2-317
© 2000, ADC Telecommunications, Inc.
DLP-775
Page 2 of 3
9. The file: /cellworx/config/config.snmp.active is READ-ONLY, so save the file in vi by
entering the command string :w!
10. The vi will display a confirmation message that the file has been written. Exit vi by
entering the command string :q!
11. Repeat this procedure starting at step 1 replacing /cellworx/config/config.snmp.active with
the directory string /cellworx/config/config.snmp.local.
12. Once completed, perform this procedure on the stand-by NMIC also.
Stop! You have completed this procedure.
# WARNING ::::
#
# Default agent configuration file. Please DON'T modify if you don't know
# what you are doing because it can have adversed affect on the NMIC software.
#
# WARNING ::::
# !!! START USER CONFIGURABLE PARAMETERS.
#
# The following lines are the only one that may be configurable by the user.
#
# Each "MANAGER" clause define one destination. The syntax is as follows :
# MANAGER <host | IP address>
# SEND ALL TRAPS TO PORT <trap port on destination>
#
# Define the forwarding of the traps to the Cellworx GUI
MANAGER localhost
SEND ALL TRAPS TO PORT 10162
# !!! END USER CONFIGURABLE PARAMETERS.
# WARNING :::
Figure 775-1. Unmodified SNMP Trap Host File