ADC Release 3.1 - Manual (Page 206)

1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2-186

2000, ADC Telecommunications, Inc.
DLP-737
Page 3 of 8
15. The system now attempts to verify the new NE is connected correctly over both ring
directions, indicated by the pointer on step 15 of the Task Overview window. The
“Discovering Network” message window appears as shown in
Figure 737-12 . Discovery
verifies the physical connectivity between the nodes and should take less than ten seconds.
16. The system now restores all traffic across both ring directions through the new NE.
Subsequently, the “Add NE” task is complete and the topology is updated as per step 17 of
the Task Overview window. The system responds with a message window indicating that it
is updating the network topology and to please wait. Refer to
Figure 737-14 .
18. The user will be prompted to save the new icon layout. Refer to Figure 737-15 . To do this,
select the disk icon on the tool bar above the work area or select the File pull down menu
and Save Icon Layout or by entering Alt+F followed by an Alt+S on the keyboard. Refer to
Figure 737-16 .
19. The user may now provision the new node per NTP-006 .
Stop! You have completed this procedure.
Cellworx Vision Subnetwork Management System
File Configuration Fault Performance
Software
NMIC Platform
Topology
Time and Date
Connection
10966-E
Refresh...
Remove Expansion Shelf Network Element
Remove Ring Network Element
Add Expansion Shelf Network Element
Add Ring Network Element
Force Network Discovery ...
Turn Up Ring...
Revert to Saved Icon Layout...
Ring Audit
Ring Upgrade
Figure 737-1. Cellworx Vision Configuration Pull Down Menu