ADC Release 3.1 - Manual (Page 382)

1152700 • Issue 1 • February 2001 • Operation and Maintenance
Page 2-362
© 2000, ADC Telecommunications, Inc.
DLP-785
Page 6 of 7
Table 785-2. FT1 FRS Configuration Options, Continued
SELECTION DEFAULT OPTIONS DEFINITIONS
Loopback None None
Facility Line
Terminal
Facility
Payload
No Loopback selected.
Loops frames back out to EIM after assigning
overhead and buffering.
Loops ATM cells back to Cellbus.
Loops the payload back to customer interfacing
equipment before assigning overhead and buffering.
Far End Loopback None None
Line
Payload
Reset
No loopback is requested.
Tells the far end to loop the line back.
Tells the far end to loop the payload after line data is
extracted.
Tells the far end to stop the loopback.
Cellworx Vision: Frame Relay Interface X
Delete Apply
Node Name:
Node ID:
Location:
NE-2
4
Broadway
Slot Number:
Card:
Port Number:
6
FT1 FRS
4
Double click on an interface to display it.
Select a channel number with the left mouse button to start channel selection.
Select a channel number with the right mouse button to end channel selection.
Select a port to switch ports.
Port Channel
1
2
3
4
X
X
X
X
1 2 3 4 5 6 7 8 9
Interface selection enabled
Interface creation allowed
Interface Name:
Interface Contact:
Interface Location:
Recording Interface Id:
Operational Status:
Provisioned Endpoints:
DLCI Length:
Used Bandwidth:
Ingress: % Egress: %
Effective Bandwidth: %
Interface Type: IWF Type:
UNI NNI FRF.5 FRF.8
Refresh Card View Close
DS0-E0 FRS : Slot 04 : Port 01 : Channels 01-24
default
default
0000000000000000
Up
0
2 Octets 10 Bits
0.00 0.00
100.00
Signaling Parameters
Signaling Protocol:
None LMI Rev1 Annex D: ANSI T1.617D Annex A: CCITT Q
2
Current
1
SELECT THE FIRST
CHANNEL AND/OR THE
LAST CONTIGUOUS
CHANNEL TO CREATE
AN INTERFACE.
DOUBLE-CLICK ON
A PORT TO CHANGE
TO THAT PORT FOR
INTERFACE CONFIG-
URATION.
SELECT THE APPLY
BUTTON AFTER CREATING
EACH INTERFACE ON THE
PORT.
DELETES THE INTERFACE
SHOWN AS "CURRENT"
ABOVE. RETURNS TO THE
CARD VIEW. REFRESHES
SCREEN
DATA. CLOSES THE WINDOW
AND RETURNS TO THE
CARD VIEW WINDOW.
DISPLAYS NE AND
CARD TYPE/SLOT
INFORMATION.
0026-012
Figure 785-4. FT1 FRS Interface Configuration Window