Allied Telesis AT-S63 - Manual (Page 196)

Chapter 12: File System Commands
196 Section II: Advanced Operations
SHOW CONFIG
Syntax
show config [dynamic]
Parameter
dynamic Displays the settings for all the switch and port
parameters in command line format.
Description
This command, when used without the DYNAMIC parameter, displays two
pieces of information. The first is the “Boot configuration file.” This is the
configuration file the switch uses the next time it is reset or power cycled.
This is also the configuration file the switch uses to save your
configuration changes when you use the SAVE CONFIGURATION
command. To change the boot configuration file, refer to “SET CONFIG”
on page 193.
The second piece of information is the “Current Configuration.” This is the
boot configuration file the switch used the last time it was reset or power
cycled.
An example of the information displayed by the command is shownn in
Figure 18.
Figure 18. SHOW CONFIG Command
The DYNAMIC parameter displays all the switch settings in command line
format for those switch parameters that have been changed from their
default settings. For an example of the information displayed by the
command, refer to Figure 2 on page 56.
Example
The following command displays the names of the active and current
configuration files:
show config
Boot configuration file .............. "SalesSw4a.cfg" (Exists)
Current configuration ................ "SalesSw4a.cfg"