Ping – Allied Telesis AT-S63 User Manual
Page 42
Chapter 2: Basic Switch Commands
42
Section I: Basic Operations
PING
Syntax
ping
ipaddress
Parameter
ipaddress
Specifies the IP address of an end node to be pinged.
Description
This command instructs the switch to ping an end node. You can use this
command to determine whether an active link exists between the switch
and another network device.
Note
The switch must have a routing interface on the local subnet from
where it is pinging the device. The switch uses the IP address of the
interface as its source address. For instructions on how to add a
routing interface to the switch, refer to “ADD IP INTERFACE” on
page 558.
Example
The following command pings an end node with the IP address of
149.245.22.22
ping 149.245.22.22
The results of the ping are displayed on the screen.