Allied Telesis AT-S63 - Manual (Page 210)

Chapter 13: File Download and Upload Commands
210 Section II: Advanced Operations
The following command downloads a configuration file onto a flash
memory card in the switch. The configuration file is given the name
“product_sw.cfg” on the card:
load method=xmodem destfile=cflash:product_sw.cfg
The following command downloads a new version of the AT-S63 image
file to the switch’s file system instead of the application block. It does this
by replacing the APPBLOCK option with a filename, in this case
“ats63v1_2_0.img”. The image file is stored in the switch’s file system with
this name:
load method=xmodem destfile=ats63v1_2_0.img
Since the file is stored in the switch’s file system and not the application
block, the switch does not use it as its active image file. If, at some point in
the future, you want to make it the active image file, use “LOAD
METHOD=LOCAL” on page 200.