Allied Telesis AT-S63 - Manual (Page 63)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 63
SHOW SYSTEM
Syntax
show system
Parameters
None.
Description
This command displays the following information:
MAC Address
The MAC address of the switch.
Model Name
The model name of the switch.
Serial Number
The serial number of the switch.
IP Address
The IP address of the local interface.
Subnet Mask
The subnet mask of the local interface.
Note
To manage routing interfaces and designate a local interface, refer
to Chapter 33, “Internet Protocol Version 4 Packet Routing
Commands” on page 555
Default Gateway
For AT-9400 Switches that support IPv4 routing, such as the AT-9424Ts
and AT-9448Ts/XP Switches, this field displays the IP address of the next
hop of the switch’s default route. The switch uses the default route when it
receives a network packet for routing, but cannot find a route for it in the
routing table. This field will contain 0.0.0.0 if no default route is defined on
the switch.
For AT-9400 Switches that do not support IPv4 packet routing, such as the
AT-9424T/GB and AT-9424T/SP Switches, this field displays the default
gateway address. This is the IP address of a router interface on your
network. The switch’s management software uses this address as the next
hop to reaching a remote network device when the switch’s local interface
and the remote device are on different subnets. The default value is