Purge snmpv3 access – Allied Telesis AT-S63 User Manual
Page 415
Advertising
AT-S63 Management Software Command Line User’s Guide
Section IV: SNMPv3
415
PURGE SNMPV3 ACCESS
Syntax
purge snmpv3 access
Parameters
None
Description
This command resets the SNMPv3 Access Table to its default value by
removing all the access table entries. To remove a single entry, use
“DESTROY SNMPv3 ACCESS” on page 407.
Example
The following example removes all the SNMPv3 Access Table entries:
purge snmpv3 access
Advertising