Allied Telesis AT-S63 - Manual (Page 201)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 201
ˆ After downloading an image file into the application block, you can
delete the image file from the file system or compact flash card to free
up space for other files.
Caution
The switch, after downloading the AT-S63 image file into its
application block, automatically resets to initialize the new
management software. The entire process can take a minute or so
to complete. The switch does not forward network traffic during the
reset process. Some network traffic may be lost.
Examples
This command downloads an AT-S63 image file stored in the switch’s file
system into the application block, the area of flash memory reserved for
the active running image. This makes the file the active image file on the
switch. The name of the image file in the file system in this example is
“ats63v2.img”:
load method=local destfile=appblock srcfile=”ats63v2.img”
A confirmation prompt is displayed. Type Y for yes to transfer the file to the
application block or N for no to cancel the procedure.
This command downloads an AT-S63 image file from a compact flash card
to the switch’s application block. The name of the image file on the
compact flash card is “ats63v2.img”:
load method=local destfile=appblock
srcfile=cflash:”ats63v2.img”