Allied Telesis AT-S63 - Manual (Page 502)

Chapter 29: Port-based, Tagged, and Multiple Mode VLAN Commands
502 Section VI: Virtual LANs
ADD VLAN
Syntax 1
add vlan= name [vid= vid ] ports= ports |all
frame=untagged|tagged
Syntax 2
add vlan= name [vid= vid ] taggedports= ports |all
untaggedports= ports |all
Parameters
vlan Specifies the name of the VLAN to modify.
vid Specifies the VID of the VLAN you want to modify. This
parameter is optional.
ports Specifies the ports to be added to the VLAN. You can
specify the ports individually (for example, 5, 7, 22), as
a range (for example, 18-23), or both (for example, 1, 5,
14-22).
frame Identifies the new ports as either tagged or untagged.
This parameter must be used with the PORT
parameter.
taggedports Specifies the ports to be added as tagged ports to the
VLAN. To include all ports on the switch as tagged
ports in the VLAN, use ALL.
untaggedports Specifies the ports to be added as untagged ports to
the VLAN. Specifying ALL adds all ports on the switch
as untagged ports to the VLAN.
Description
This command adds tagged and untagged ports to an existing port-based
or tagged VLAN.
Note
To initially create a VLAN, see “CREATE VLAN” on page 505. To
remove ports from a VLAN, see “DELETE VLAN” on page 509.