Show igmpsnooping – Allied Telesis AT-S63 User Manual
Page 361
AT-S63 Management Software Command Line User’s Guide
Section III: Snooping Protocols
361
SHOW IGMPSNOOPING
Syntax
show igmpsnooping
Parameters
None.
Description
This command displays the IGMP parameters. Figure 30 illustrates the
information that is displayed by this command.
Figure 30. SHOW IGMPSNOOPING Command
For an explanation of these parameters, refer to “SET IP IGMP” on
page 358 and “SHOW IP IGMP” on page 363.
IGMP Snooping Configuration:
IGMP Snooping Status ............... Disabled
Host Topology ...................... Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum IGMP Multicast Groups ...... 64
Router Port(s) ..................... Auto Detect
Router List:
VLAN
Port/Trunk ID RouterIP
----------------------------------------------------
1
14/-
172.16.01.1
Host List:
Number of IGMP Multicast Groups: 4
VLAN
Port/
IGMP
Exp.
MulticastGroup ID
TrunkID
HostIP
Ver
Time
------------------------------------------------------------
01:00:5E:00:01:01
1
6/-
172.16.10.51
v2
21
01:00:5E:7F:FF:FA
1
5/-
149.35.200.75 v2
11
149.35.200.65
v2
65
01:00:5E:00:00:02
1
17/-
149.35.200.69 v2
34
01:00:5E:00:00:09
1
14/-
172.16.10.51
v2
32